Are you familiar with the situation when you apply foundation and an hour later your face looks like a map with spots of varying intensity? Uneven traces, "sticking" on the wings of the nose and the effect of a mask are the main signs that the technique requires refinement. Let's figure out how to apply tone professionally so that the coverage is flawless and natural.

 The main mistake of the majority is to apply foundation like a regular moisturizer, chaotically smearing it all over the face from the center to the periphery. As a result, there are too many funds in some places, and almost none in others. To avoid the "leopard" color, it is worth adhering to a proven scheme.

Step 1: Preparation — 50% success rate
No remedy will fall flat on dehydrated or insufficiently cleansed skin.

The "three minutes" rule: After washing, apply a moisturizer and let it soak for 3-5 minutes. If you start applying makeup right away, the tone will "float" and roll down.
Step 2: "The five-dot method" (and a few secrets)
Don't squeeze the cream all over your face at once. Professionals recommend placing five key points: forehead, nose, chin and two cheeks.

 However, the secret is not in the points, but in the direction of movement:

Start from the center of the face. It is here that the main imperfections (redness, enlarged pores) are concentrated.
Blend to the periphery. By the hairline, ears and lower jaw, the layer should fade away. This will prevent the appearance of sharp borders.
Instead of "rubbing in", use "pressing in". If you're using a sponge (beauty blender), move in a tapping motion. Stretching the skin with a brush often creates streaks, while a sponge allows you to mimic the texture of live skin.
Step 3: Focus Areas
These are the areas where "spots" often appear:

The wings of the nose: the skin here often peels. To prevent the tone from getting stuck in these creases, apply the remaining cream from the sponge with light tapping motions, without taking on a new portion of the product.
The area around the lips: Excessive tone here will immediately highlight the facial wrinkles. Here, the layer should be as thin as possible, almost transparent.
Transition to the neck: To avoid the face looking like a separate mask, "reduce" the remaining tone on the sponge to the submandibular bone.
Step 4: Quality Control
After you've applied the foundation, step back from the mirror for half a meter and look at your face in daylight, preferably near a window.

 If you notice any obvious spots, use a clean, slightly damp sponge to apply a thin layer of foundation over them. This will help absorb any excess pigment.
If you don't have enough coverage in certain areas, don't spread the product; instead, use a sponge to apply a small amount of foundation directly to the problem areas.
The key takeaway: less is more.
The "leopard effect" is often caused by applying too much product. It's better to apply a thin layer and then use concealer on problem areas rather than trying to cover your entire face with a thick layer of foundation. 

 Remember that high-quality makeup is about showing off your beautiful skin, not covering it up with makeup.  Follow these simple steps, and your reflection in the mirror will be flawless all day long!